|
Tractor Talk Discussion Board |
Re: Re: Narrow vs. Wide front ends
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by rustyfarmall on April 01, 2003 at 12:38:24 from (207.32.13.218):
In Reply to: Re: Narrow vs. Wide front ends posted by Dave 2N on April 01, 2003 at 12:15:47:
Didn't think I would get involved with this either, but, here goes. There was a study done several years ago by one of the major ag. colleges, I forget which one now, but this study revealed that a narrow front was actually LESS likely to roll over because of the front tires being located on either side of the center pivot point, unlike a wide front, which can pivot directly on the center pivot point. After saying all that, you should make up your own mind about which to get.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Tractor Proflie: Farmall Model C - by Staff. In 1948 the first Farmall Model C tractor rolled out of the factory and into the farmer's field. A follow-on to the Model B, it was slihtly larger in size but kept the same 113 CID engine and 4-speed transmission. Other upgrades included adjustable rear tire spacing (with sliding hubs), a frame design similar t
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|