Re: Beading a tubless tyre

Posted by noncompos on June 17, 2007 at 21:28:28 from (67.42.238.248):

In Reply to: Beading a tubless tyre posted by Bill from Scotland on June 17, 2007 at 15:03:53:

Ive changed a few that were faily flexible, not really tough,stiff truck tires: run a heavy chain around the tread; run a threaded rod thru one end link(held by washer and nut on that end of rod) and through a link on other side, leaving 6-8-10" space. Run nut and washer down other end and tighten (use a short piece of pipe as a spacer to give you wrench room). Tightening squeezes the center of the tread, pushing out the sidewalls enough to hold air.

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]