|
Tractor Talk Discussion Board |
Re: Re: Re: The Howard Rotavator Bantam
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by MIKE PRITCHARD on March 09, 2003 at 03:28:47 from (195.92.168.168):
In Reply to: Re: Re: The Howard Rotavator Bantam posted by Chester Hudson on October 31, 1999 at 05:07:49:
9th March 2003 Mike Pritchard
Pentre Haughton
Haughton
Llandrinio
Llanymynech
Powys
SY22 6SH
Tel: (01691) 831416
Fax: (01691( 831462
Mob: (07989) 346252
E-mail: [email protected] Dear Mr. Hudson I have just found your message (31/10/1999) relating to parts for the Howard Bantam. I have just acquired one that wont start and needs a good service. I was wondering if you were in a position to sell me a manual and then parts as required. Regards Mike Pritchard
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
