Tractor Talk Discussion Board |
Re: Re: Re: 95psi good compression
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by G-MAN on February 25, 2003 at 10:39:08 from (206.106.139.74):
In Reply to: Re: Re: 95psi good compression posted by MARK TX on February 25, 2003 at 07:51:56:
There is no hard and fast rule for proper compression on a gas engine. It depends on a number of factors - compression ratio, cranking speed, intake restriction and so on. You can't just pick an arbitrary number and say that compression should be at least such and such - you need to get the proper specs for whatever engine you're working on. Case in point - compression psi on a Deere gasoline 3010 should be 160 psi - on a Deere gasoline 2510, it should be 185 psi - and both are measured at 170 rpm cranking speed. Notice the substantial difference. The main thing to look for when checking compression is balance between the cylinders. There really shouldn't be more than about a 10% variance from cylinder to cylinder. An engine with slightly low compression but that has pretty much equal readings on all cylinders will run much better than one with three good cylinders and one that is much lower. I would suggest getting the proper service manual for your tractor and going from there. You're compression may not be as bad as you think it is. If it is low, perform a wet compression check to determine if it's the valves or the rings causing the problem. No sense doing a complete overhaul if a valve grind would cure the problem. Also make sure that your throttle is wide open when checking compression. Not doing so is an easy mistake to make.
Follow Ups:
Home
| Forums
Today's Featured Article -
What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|