|
Tractor Talk Discussion Board |
Re: Re: Re: Re: Re: Re: Emergency Power Generator
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Ben in KY on February 14, 2003 at 10:28:31 from (192.76.82.90):
In Reply to: Re: Re: Re: Re: Re: Emergency Power Generator posted by Bob M on February 13, 2003 at 13:15:05:
Yep was wondering if anyone would get around to the side pressure angle on the generator shaft. Not usre about your generator but most seem to be set up to bolt straight onto a motor output shaft. Their front shaft bearings are not engineered for the side pull of a belt drive, thus they will not last too long when used in this application. You can work around this limitation by using a bearing supported jack shaft, with the pulley on one end and a coupler on the other end connected to the generator input shaft. I have had to do this on hydraulic pumps that were designed for direct shaft drive.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Talk of the Town: Trailerin a Tractor, Chains or Straps? - by Staff. Another great discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: " I bought a trailer and plan to take my CASE VAS to some shows. I don't yet have anything to secure it to the trailer. So which is better to buy and use; the ratchet-type straps or binders and binder chains?
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
