|
Tractor Talk Discussion Board |
Re: Tractor PTO's
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by JD70Jim on February 14, 2003 at 07:15:54 from (12.215.70.158):
In Reply to: Tractor PTO's posted by Christine on February 13, 2003 at 14:37:29:
Christine: Your question is one of those which when asked (in innocence,by someone who has no idea at all) of someone who uses the equipment, causes hysterical laughter---all at your expense! It isn't your fault that they laugh, but the question is, to them utterly simple! I will, however, explain. A power take off, commonly refered to as a PTO, is a rotating shaft, usually 1 3/8" in diameter, with splines on it, located just above and in line with the tractor drawbar. It transfers power from the tractor engine (just like the driveshaft on a car or truck) to the towed or mounted implement. The splines on the shaft match the splines on the implement's driveshaft and there will be a device to lock the connection so that the driveshaft won't come off while operating, but can be disconnected easily when unhooking the implement. There are also "mid mounted" pto and "front" pto locations on some tractors. The "Mid" or middle mounted pto is also in line with the centerline of the tractor, but faces forward and is located under the tractor. but in front of the rear axle and under the transmission. Much more rare would be a "front" pto, which would be located between the front wheels, in front of the tractor and would be used with very specialized equipment. Front pto is highly uncommon. Does this answer the question? Good luck with the Horse Farm Management class.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Museum Coverage: The Stuttgart Agricultural Museum - by Cindy Ladage. While cold wind was blowing back in Illinois, in Arkansas, daffodils were in bloom, and the Magnolia trees were adorned with fragrant blossoms. Stuttgart, Arkansas was the site of this year's winter Minneapolis Moline Collector's show February 25-27, 1999. The show was held at the Oliver Museum created by Don Oliver, the pioneer of the four wheel drive tractor. Oliver along with Gale Stroh and Kenneth Bull using Minneapolis Moline tractors and parts created what has become known as
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|