Tractor Talk Discussion Board |
Re: Emergency Power Generator
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by JT on February 13, 2003 at 09:11:19 from (206.72.35.208):
In Reply to: Emergency Power Generator posted by Two Bit on February 13, 2003 at 06:06:11:
Don't know where these two are coming from. Horsepower is the combination of Force and Speed. One formula is (Torque{ft lbs} X RPM)/5252. What you are proposing to do is step up the SPEED which will step down the FORCE torque in this example. The horsepower will stay approximatly the same allowing for mechnical losses. Another way to explain this is take a 30-60 Aultman Taylor and a 3020 John Deere. The Aultman is rated at 30 drawbar HP and the 3020 about 60 dbhp. The 30-60 in my area will pull a 6 to 8 bottom plow very effectivly while the 3020 would have a hard time with a 4 bottom. Why? The Aultman is exerting A LOT (about twice) more force than the JD but is doing it about a fourth the speed. All in all what you are proposing will work great. I have a 20 kw pto generator with a JD A. On the front of the Generator is a gearbox that steps up the Speed from 500 to 3600. HTH JT
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|