Tractor Talk Discussion Board |
Re: 1655 cockshutt plumbing
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Mike (WA) on February 13, 2003 at 07:48:48 from (209.245.162.156):
In Reply to: 1655 cockshutt plumbing posted by keith martin on February 12, 2003 at 12:39:22:
On the 50 series Olivers, the power beyond plug is toward the left front top corner of the housing, I think- you're looking for a 1/2 inch pipe plug which, when removed, reveals another 3/8 pipe thread port inside. Plug the 3/8 port with a pipe plug, and you have constant pressure oil. The return port is lower down on the housing, also on the left side, I think. BUT- I have read some discussions about the 55 series being a closed center system (50 series is open center)- so you may want to put your question on the Oliver board to get confirmation.
Follow Ups:
Home
| Forums
Today's Featured Article -
What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|