|
Tractor Talk Discussion Board |
Re: 12 volt electric winch
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Gary (Ont) on February 12, 2003 at 14:08:54 from (199.243.72.93):
In Reply to: 12 volt electric winch posted by rustyfarmall on February 12, 2003 at 12:48:33:
I have a 18 foot trailer and the whole bed tilts at a 10 degree angle for loading (no ramps). Using a 4500 lb. winch with a single line pull I have loaded cars up to about 3500 lbs. Any heavier than that and the breakers kick out. If you use a pully block and double up the cable you can pull a much heavier load but at about half the normal speed. I heard you can pull twice the load this way but I'm no engineer.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Adding an Hour Meter - by Steven Gussey. This article tells how I added an electric hour meter to my 1942 Farmall H after rebuilding it. I wanted to keep an accurate maintenance schedule for my rebuilt engine and the implements I use with my tractor, but the H was never available with a tach
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|