Tractor Talk Discussion Board |
Re: Re: Charging a 6 Volt with a 12 volt
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Ben in KY on January 25, 2003 at 16:35:58 from (207.246.76.125):
In Reply to: Re: Charging a 6 Volt with a 12 volt posted by Fred OH on January 25, 2003 at 11:25:44:
Fred, Your method will work, if you hit the straps between the cells and do not screw in between the plates and short out the cell. This can be Very bad and I cannot recommend your method. It would also be a low current solution to drop the voltage. If you want to drop the voltage from 12 to 6 volts for an accessory, I recommend getting a voltage divider as spoken of by donlc in his post below. However the poster is wanting to charge a 6 volt battery with a 12 volt charger, different then cutting down a 12 volt battery to 6 volts.
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|