Re: 1951 VAC

Posted by Lew on January 22, 2003 at 20:34:52 from (207.190.81.60):

In Reply to: 1951 VAC posted by Dave L. on January 22, 2003 at 12:19:09:

Dave, I just measured my 1951 VAC with the hubs in the "normal" configuration and placed very near the end of the axle. 72" from outside of one tire to the outside of the other. I have never readjusted mine but they are movable if they are not chemically bonded by age to the axle. Some parts are cast iron so hammering is to be done gently. It appears if the fenders were off that the width could be shrunk to about 50". Hope this helped. Lew Van Vliet, Wisconsin. Yes it is cold out and I measured fast but my answer has no more than a 4% error margin. That's better than most polls.

Follow Ups:

Post A Followup Name: E-Mail: Subject: Re: Re: 1951 VAC Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]