|
Tractor Talk Discussion Board |
Re: Re: Re: cylinder ridge
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Ed on January 22, 2003 at 18:35:57 from (63.147.130.38):
In Reply to: Re: Re: cylinder ridge posted by Glenn Ayers on January 22, 2003 at 14:16:24:
Not nescisarly. It is possible for there to be a ridge and the cylinder wall/piston clearance can still be acceptable. Its kind of like rod and main bearings. 3 to 5 thousands is acceptable clearance. Under 3 (it is to tight), over 5 (it is to loose). There is a little lee-way as well on the cylinder walls. Maybe just a few thousands of an inch but hey, a couple thousands will catch a finger nail if it is a good ridge. A good repair manual will give you acceptable clearance guidlines to follow when you conduct your diameter and out-of-round measurements. A good manuel will also give you some guidlines on the rings as to how they fit and if they are acceptable.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
On the Road with Dave Gohl: Deere Departed Friend - by Dave Gohl. Have you ever had to part with a dear friend? It's not easy. If it's due to death, your feelings could be in disarray for days, months or even years. Even now after almost 4 years, I still miss my dad. I remember when I was a kid my dad sometimes would tuck my brother and I in at night and we would ask him questions about his childhood on the farm. To this day, it's some of the best stories I've ever heard. And now, I'm so glad that I asked those questions, and if I were a little smarter i
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
