|
Tractor Talk Discussion Board |
Re: stupid question for the day
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob M on January 21, 2003 at 12:54:58 from (165.170.128.66):
In Reply to: stupid question for the day posted by Terry on January 21, 2003 at 07:21:26:
Terry - Propane can work, and you don't need to worry about it "blowing up" your motor. While propane indeed has a high octane rating, this merely means as a motor fuel it is more resistant to knock than is regular or hi-test gasoline. It doesn't mean it is more "explosive" or otherwise hard on an engine. Rather what is important here is energy density. And propane has a LOWER energy density than gasoline or distillate. Which simply means if your motor is OK with gasoline and distillate, there's no way you can harm it on propane. However there are a couple practical matter to using propane as a starting aid: 1 - Like any other fuel, propane must be properly proportioned with air in order to fire the engine. Too little (lean) and nothing will happen. Too much (rich), again nothing happens. Getting the proper fuel/air mix by directing an unlit torch into the carb is an imperfect process at best! 2 - Propane is much heavier than air. Means that with an updraft carburetor, unless one person directs the propane into the carb inlet as the other cranks, the injected propane will simply run right back out of the carburetor and dissipate on the ground while you go around front to yank the crank. If it were me I'd buy a can of ether starting fluid and use it sparingly per the instructions. WD-40 works pretty well too so long as the temperature is about about 20 degF...
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
