Tractor Talk Discussion Board |
Re: ford 3000 pto
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Doug on January 15, 2003 at 15:51:24 from (208.59.158.191):
In Reply to: ford 3000 pto posted by wyatt on January 15, 2003 at 14:27:23:
Wyatt: Don't know if this'll help, but I have a similar problem with the PTO lever staying engaged on my 1990 JD955. I have a tandem lever arrangement, where the top lever goes out thru the dash to the handle I slide up for PTO; there is a second lever inside the engine compartment that actually engages the PTO drive; it connects to the top lever by a magnetic latch just inside the instrument panel. Must be a safety mechanism. For a quick fix until I can actually repair it, I twisted some insulated wire between the two levers so both lift in tandem when I slide the PTO lever. Perhaps Ford had a similar safety interlock??? Hope that helps. Doug
Follow Ups:
Home
| Forums
Today's Featured Article -
What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|