|
Tractor Talk Discussion Board |
Re: Re: Re: Re: Just what would you do?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Punchie on January 08, 2003 at 20:55:16 from (63.168.194.167):
In Reply to: Re: Re: Re: Just what would you do? posted by 306m-puller on January 05, 2003 at 09:30:11:
HI forum A 22 mag is a little small for the gut shooting , I think that is heart less to do with that small of a gun. Before any of you jump me about animal lover , you bet. Love all of God's animals the best way I can. Please take a bigger gun , shotgun or rifle down load a bit, to do that if you must. 22 mag energy ME would be around 100-200 22 short ME 40-60 22 Long ME 60-100 It would take around 500 at least to kill it with in a fair amount of time, like a day or longer. Now a very high velossity ( spelling) fast in the right size like 300 ackly 130 gr bullet 30 ca. going at 3600 or faster would just about kill it in its tracks or at least with a big whole going out the other side. It may go but not too far would die in first 1/4 mile. 3-4 hours at most. Back to arrows , here in PA I worked as a deer cutter , not a butcher, a meat cutter. Yes there is a differents. The old friend that show me was close to 80 started when he was 9 cut meat for a living. It is funny how they can go the deer with arrows gun shots etc. out of 300 deer average he did for all of those years he said that he would find two -three arrows , and a about the same broken bones and gun injures that would heal over a year so about 2 % is about right , the short time I cut with him we found one arrow head still there all amost a foot long 1/2 " away from the spine right between the shoulder blades. Love God's animal's kill when and if you have to. Punchie
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|