|
Tractor Talk Discussion Board |
Re: Re: No crank
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by rob nickel on December 21, 2002 at 12:28:44 from (24.69.255.236):
In Reply to: Re: No crank posted by rod on December 16, 2002 at 19:14:25:
Probably a good idea to hook up a charger to your battery first as you'll need lots of cranking power to bleed the system. Some diesels come equiped with a hand pump on the side of the engine to help pump up the fuel while bleeding and they usually do the job given you don't mind cranking this sucker for hours on end? I use ether after cracking bleeders and lot's of it until she go's again but not everyone cares to do this? Hard on the crank con rods etc... if too much is used so be carefull OK?
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Weldin Basics, Part 3 - by Curtis von Fange. Oxy-acetylene Welding - Part One In our series on welding we have taken a brief look at AC and DC arc welding along with basic techniques and safety equipment required for safe usage. Since our premise is to cover welding types that might best be used on a farm environment we have kept our overview purposefully simple and general. The second type of welding that this observer finds quite useful in
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|