|
Tractor Talk Discussion Board |
Re: Re: Re: Wheel fell off
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dennis Benson on December 09, 2002 at 17:12:44 from (205.188.209.109):
In Reply to: Re: Re: Wheel fell off posted by Alton on December 09, 2002 at 16:59:48:
If that happens again it is helpful to have a couple thread files. They have 4 sides, and toward the end of each side they have a different number of threads per inch for a total of 8 different threads per inch on each file. You just pick the correct number of threads per inch, lay the file in the threads, at a 90 degree angle to the shaft and file out the rough or rounded spots until the nut screws on easily. That works nicely if you have an non stnadard size. I also have a metric thread file. You can save a lot of threaded parts this way.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
65 massey ferguson diesel
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
