|
Tractor Talk Discussion Board |
Re: Re: Pulling stumps
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Renze on November 29, 2002 at 11:00:07 from (213.75.177.212):
In Reply to: Re: Pulling stumps posted by Ed on November 24, 2002 at 05:42:25:
No, traction alone wont do the job... I have pulled 12" stumps with my 50 hp Zetor 5245 4wd. The trick i use: I hook the chain on the top link of my 3p hitch earth bucket. The high attachment point gives some serious weight on the rear axle, to increase traction, and the bucket will make it impossible for the tractor to pull back over. When i have pulled the chain tight, i lift the bucket high up, and when the front axle is raised high enough, i let the bucket go up and down. This causes some SERIOUS peek forces, what will break about any root. Judt one advice: Always use your differential lock, otherwise your diff's satelite carrier shaft will wear out (like mine)
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Usin Your Implements: Bucket Loader - by Curtis Von Fange. Introduction: Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he rea
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
