|
Tractor Talk Discussion Board |
M W Hand Clutch for Farmall MD needs help!
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Ken on November 28, 2002 at 10:21:12 from (63.27.134.63):
Bought a Farmall MD last winter with a M & W hand clutch that was rusted tight. I tried to get it appart with out any luck so I used the tractor without it working. I was making a corner with the haybine and the clutch started to slip. (Rust let go.) I tightened the nut to get the clutch from slipping but when I back up, the clutch jumps out. I sounds like there is a bad bearing inside the clutch. Talked to CIH dealer and they think there are no replacement parts for that clutch available. Does anyone have any info on this clutch and if there are any known parts available? Any information or remedies for fixing this clutch would be appreciated!
Follow Ups:
Home
| Forums
Today's Featured Article -
My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
