|
Tractor Talk Discussion Board |
Re: Suggested Manufactories for Metal Buildings
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by T_Bone on November 15, 2002 at 11:13:52 from (64.157.196.64):
In Reply to: Suggested Manufactories for Metal Buildings posted by Russ on November 15, 2002 at 09:51:47:
Hi Russ, One 10 x 10 door? Ten high sounds ok but 10 wide to me is too narrow. Maybe 16 wide would work best. Or a 20ft with a split 10 so you can open one side. On metal buildings the quality comes from how thick the metal is. Naturally the thicker the better. A Frame building is better than one without a frame. T_Bone
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Little "M" - by Donnie Anderson. They call me "Little M" and this is my story. For the past several years I have sat against the tree-line, where my parts have rusted and rotted away. For all of these years I have wondered just exactly what happens to old tractors? Times were not always like this. I can remember back to 1948 when I was a brand new John Deere Model M. A man and his wife came to the dealer and looked me over real good. After many talks with the salesman a deal was struck and I, along with a M2 plow, c
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
