|
Tractor Talk Discussion Board |
Re: International 1466 Diesel Engine
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Steven@nd on October 22, 2002 at 11:00:33 from (165.234.131.150):
In Reply to: International 1466 Diesel Engine posted by Walt on October 22, 2002 at 04:16:29:
That is fairly low hours on a 400 series IH engine. Our 1086 had 7500 hours on it when we overhauled it, due to low oil pressure. It needed only bearings but we went all the way while we were in there. It is recommended to put in new rod and main bearings around 4000 hours, but most run 5000 or 6000. If it doesn't have a water filter, put one on it or change coolant every year. That engine will cavitate and destroy itself if the pH of the coolant is off. Rated at 133 hp on the PTO and 118 hp on the drawbar. However, our 1086 has the DT414 engine and is rated the same as yours, but puts out 150 on the PTO.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Tuning-Up Your Tractor: Secondary Ignition Wires and Distributor - by Curtis Von Fange. In our last episode we spent the entire day checking out the spark plugs. Is that efficency? Actually, it took more time to explain than it really did to do the inspection. At any rate we decided that a compression test was in order so we could verify the internal engine status. That way we wouldn't buy any tune up parts until we were sure that the engine was in reasonable mechanical condition. Our tests showed a fictional compression reading of 85, 80, 82 and 86 psi. That is well within a
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
