Re: Need a float level spec for a Zenith carb

Posted by Larry from Maryland on October 02, 2002 at 09:29:48 from (208.10.124.69):

In Reply to: Need a float level spec for a Zenith carb posted by Amateur Mechanic on October 01, 2002 at 12:11:12:

You have the same carb that I have.I have mine set at 1/4 inch.The ajustment needle is probably what came in that carb,mine is the same.These carbs where likely universial replacements from zenith.Mine has numbers cast into the top of the inside of the fuel bowel.There is allso some numbers stamped into a metal plate on top,unfortunetly I have been unable to read all of them.My engine starts by hand crank and seems to run well untill it needs power then it wont pull hard.

Follow Ups:

Post A Followup Name: E-Mail: Subject: Re: Re: Need a float level spec for a Zenith carb Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]