Tractor Talk Discussion Board |
Re: Unorthodox Repair
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dennis Benson on September 23, 2002 at 19:16:24 from (205.188.209.109):
In Reply to: Unorthodox Repair posted by moonlite on September 23, 2002 at 17:34:00:
About 25 years ago I was working in an engine rebuilding shop. I disassembled and cleaned everything that came in. One day a antique Chrysler flathead 6 came in, it had over an inch of crud, while scraping off the grease and gravel I found on the top of the lip where the oil pan bolts I found a 3 inch Snap On crescent wrench. I still have it, but that was not the unusual part. Replacing one of the soft plugs was a brass shell from a very large bullet, it was a perfect fit.
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
John Deere B 1943
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|