|
Tractor Talk Discussion Board |
Re: Advise needed - Avoiding a roll-over
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Brad on September 23, 2002 at 17:51:52 from (128.173.38.166):
In Reply to: Advise needed - Avoiding a roll-over posted by Jerry on September 23, 2002 at 07:36:21:
I live in VA and have some of the steepest land around. I have a Farmall 656 hydro. It does very well on the hills. It is a tall tractor. When I get to steep it lets me know. I can look down and watch the rear tires walking down hill or can fill it slipping. My point is this. First no one has mentioned that weight also plays alot in the game of staying on the hills. I work for the state and have been on some really steep hills mowing on the interstate. We have 3930 Fords or 4630 Fords. They are a heavy built tractor. Most of the time when a tractor company makes a tractor they will make two versions of the same. Not necessarily a utility vs. a row crop. But they will have two equally horsepower rated tractors but with about 2,000 lbs difference in the weight. Second no mater what you buy drive it round on flat ground and get used to and and learn where every leaver is and what it does. If not you might get on the hill and hit a stump with your bushhog and panic and cant cut your pto off. But like I said being comfortable with and knowing your tractor will save money in fixing it and maybe your life. My 2 cents Brad
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Machine Shops - by Curtis Von Fange. It is a story that repeats itself countless times. In the process of rebuilding a particular section of the tractor there is a broken part for which a replacement cannot be found. The parts houses find in their catalogue that it is unavailable. The dealerships call it a discontinued part. Salvage yards define it as hard to find or, even worse, rare. Everyone on the NET says, 'what is it?' But don�t despair there is another avenue that can be used to get that piece repaired. The local mach
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|