|
Tractor Talk Discussion Board |
Re: Advise needed - Avoiding a roll-over
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Randy V. on September 23, 2002 at 12:17:10 from (65.199.30.226):
In Reply to: Advise needed - Avoiding a roll-over posted by Jerry on September 23, 2002 at 07:36:21:
I would agree that a tractor with a lower center of gravity will do better on hills. I have a IH 544 Utility gas that is 55 HP and also a 901 ford row crop and the 544 defiantly feels better on hills. Good brakes are also a must on hills as well as a roll bar and seat belts. Before purchasing a tractor make sure you can get a roll bar if it does not already have one. They are around $750 or so. Note: An IH Farmall is a tall tractor and the International Utility is shorter or lower to the ground. Parts are easy to get for IH, Ford, and JD.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Machine Shops - by Curtis Von Fange. It is a story that repeats itself countless times. In the process of rebuilding a particular section of the tractor there is a broken part for which a replacement cannot be found. The parts houses find in their catalogue that it is unavailable. The dealerships call it a discontinued part. Salvage yards define it as hard to find or, even worse, rare. Everyone on the NET says, 'what is it?' But don�t despair there is another avenue that can be used to get that piece repaired. The local mach
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|