Tractor Talk Discussion Board |
Re: New to this
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Scott(TN) on August 29, 2002 at 05:54:22 from (138.164.194.139):
In Reply to: New to this posted by Rick T on August 28, 2002 at 18:41:20:
I also was nervious about running a tractor with a narrow front end. However, after owning one, I must admit I like it much better for mowing. trailering, etc than the wide front end machine that I have. The narrow front is much more manurvable than the wide front, backing a trailor is easier also. I have the rear tires set wide to help keep the tractor more stable and use caution when driving it on the hills. When I need to load the tractor on a trailor I just reset the width of the rear tires. Research, research, research, is about all I can suggest for you as to what type of tractor to look for. I suggest that you read the archeives on this web site, in those you will find tons of information on each type of tractor. You will find that most of the questions you have, or will have, some one else has had and been answered. You will also find that all makes and models have thier own unique quirks and issues. You will also start to find patterns developing for each make and model of tractor. Decide from that which tractor you should seek out. Take your time! Look at many tractors, try to drive as many as you can. Mechanics are of the utmost importance and paint will hide alot of sins. Also, new paint will not help the tractor run/operate any better. Just my thoughs. Hope they help.
Follow Ups:
Home
| Forums
Today's Featured Article -
My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|