Tractor Talk Discussion Board |
Re: Re: Re: Re: Re: Re: Re: Re: Re: $$$$$$$$$$$$$!!!!!!!!!!!!!!!!!
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by G-MAN on August 23, 2002 at 08:51:15 from (206.106.139.74):
In Reply to: Re: Re: Re: Re: Re: Re: Re: Re: $$$$$$$$$$$$$!!!!!!!!!!!!!!!!! posted by gy3020 on August 22, 2002 at 20:47:23:
Determining the condition of the shifter and the shift linkage is definitely the first thing to do when dealing with this problem on a New Generation tractor. You'll also want to check the end play of the shifter shafts in the case. Your service manual will lay out the adjustments and other items to check, as these items are much easier to check and repair than going into the trans. If it's been grinding going into gear, you still may have some synchro troubles there. Deere offers a kit that contains the parts necessary to rebuild the synchros on those tractors.
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|