|
Tractor Talk Discussion Board |
Re: Plowing Question
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bill Smith on August 14, 2002 at 21:40:26 from (128.242.4.59):
In Reply to: Plowing Question posted by Mark on August 14, 2002 at 19:09:40:
There is ussually adjustments on a plow. On a three point, most of the adjustment would be on the top link. Your lower two arms of three point ussually have adjustment as well, but if they are level they should be right (I ussually run lower arms all the way up in adjustment). If your top link is to short, your plow will try to dig severly, but if to long it won't want to go into ground. You have to find the happy medium. Ounce you get it into ground and it is in plowing position, your plow should be fairly level. When you raise it out of ground and set it on unplowed ground the front of plow should be running slightly downhill into ground. If it is bone dry compacted ground you will have trouble getting it to go into ground along with other simular conditions such as to much mulch and organic matter but if the latter is the case it should plow alright ounce you get it into ground. After making a pass or two your wheels of tractor should run in the furrow on one side (ussually the right). Plows ussually plow better with the wheel's in furrow. If your plow throws dirt right then your right wheels should be in furrow. If your plow throws dirt left then left wheel's should be in furrow. Most plows throw right but I have seen flip over three point plows that can throw both ways designed for terraces I guess. I doubt you have one of those though. That's about all I know to tell you, I hope I helped.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that�s wha
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|