|
Tractor Talk Discussion Board |
Re: allis wd with v-8
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Don LC on August 13, 2002 at 03:26:53 from (24.166.248.35):
In Reply to: allis wd with v-8 posted by ryan on August 12, 2002 at 09:39:01:
Several things that have to be looked at...I have never put a v8 in a Allis, but here is the steps needed....Make up an adapter plate to bolt the engine to the tractor trans. The adaptor must be the thickness required, so the trans. shaft will reach the pilot hole in the end of the crank shaft of the v8 engine...hope the fly wheel is large enough they generaly run about 10" to 12", you will most likely have to make a new pilot bushing...the front motor mounts will have to be made up.....tighten the bolts real good and hang on......
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Usin Your Implements: Bucket Loader - by Curtis Von Fange. Introduction: Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he rea
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
