Tractor Talk Discussion Board |
Re: Moline or Deere
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Pete-mi on July 25, 2002 at 21:14:57 from (63.74.20.140):
In Reply to: Moline or Deere posted by Jack on July 24, 2002 at 17:45:28:
They are both good tractors. Hours and condition can make a difference on price but the JD sounds to high for what you tell about it. If it is a gas it is definetly to high. Where I work we have a JD 2520 gas narrow front that in that price area or less.The 2520 is 7 years newer and has the hyd counsel on the right side of the seat. The 3010 has it on the left side of the dash which is not as handy. If gas the 2520 is also 4 hp more than the 3010. The M-M M670's were very good tractors and are 70hp. They came standard with dual hyd outlets and have a 10 speed trans where the JD only has 8 speeds. If both are gas the M-M should use about the same amount of fuel as the JD but will do more work. A neighbor had one a few years ago and he said it used less fuel doing the same work as his IH 400 did. One of the main things to check is the torque. In high is direct drive and you have engine brakeing. If there is any problems it is usually the low end and most often the spring and roller kit. Most of the time the M-M torques are cheaper to fix than the IH one are. The price of the M-M sound real good. My dad and grandpa both farmed with M-M's and were very happy with them. I work in the parts dept and most M-M parts are still easy to get. I would get the M-M yellow and keep the green in my pocket.
Follow Ups:
Home
| Forums
Today's Featured Article -
My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|