|
Tractor Talk Discussion Board |
Re: Re: Re: handicaped tractor
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by DON LC on June 21, 2002 at 19:52:15 from (24.166.244.148):
In Reply to: Re: Re: handicaped tractor posted by joe c on June 21, 2002 at 09:51:55:
GETTING ON AND OFF----I am going to use a small hoist or two way winch.First the tractor must be changed to 12v.--At first I am going to mount the hoist on the drawbar..also weld and bolt piece of 2"square x1/4" walltubing off to one side of the draw bar, with a pulley at the top for the cable to go up and over back down to my harness....I'll push the up button and with my other hand and my one leg, work myself to the seat....down the same way....I don't like the way this will look, so I am looking for a simple flat tractor roof with rolled edges ....I'll mount this roof using 2" square tubing as before.....this can be bolted to the axel housing on both sides ,front and back,like the drawbar is bolted on.....I'll try to hide the hoist up under the back corner of this roof....What do you think?
Follow Ups:
Home
| Forums
Today's Featured Article -
What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
