|
Tractor Talk Discussion Board |
Re: Re: Re: 1944 john deere model A steering trouble
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by rednekelmo on June 19, 2002 at 04:51:17 from (152.163.207.66):
In Reply to: Re: Re: 1944 john deere model A steering trouble posted by cam on June 18, 2002 at 22:06:15:
no problem just go to your JD dealer I just bought a new set last fall I think it was $26.It takes 1 front 1 rear. you have to pull the stearing shaft for the rear. then you have to reshim for the stearingshaft endplay.the dealer may give you good advice adjusting everything up.Or you can buy an I&T manual about $25 very helpful if you do much work it gives good directions it how to adjust steering. their avaliable at TSC and similar stores of online.you can also buy the service and operators manuals from JD at 1-800-522-7448. when you have the steering box apart clean out the grease and take a good look at everything to see what else might need replaced.a lot of the JD board guys use some slick50 grease with the oil to help the tractor steer better.Here is a link you might find useful.Meli's tractor school is good it's about B's but 99% applys to the A's also.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
