|
Tractor Talk Discussion Board |
Re: Ford 800 hydraulics
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Ultradog MN on June 09, 2002 at 08:48:27 from (65.25.245.165):
In Reply to: Ford 800 hydraulics posted by John Boyd on June 09, 2002 at 04:38:36:
I know the N series tractors pretty well but not the later Fords.
But isn't the hydraulic pump on an 800 similar to the Externally Mounted pump on a Jubilee?
Right side (from the seat) by the bell housing where it is run off the flywheel. This is what gives you the live hydraulics because the pump is turning whenever the engine is running whether or not the clutch is pushed in or not.
Maybe get an I&T manual for your tractor. The one I have for my N is a huge help.
Good luck
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Usin Your Implements: Bucket Loader - by Curtis Von Fange. Introduction: Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he rea
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
