|
Tractor Talk Discussion Board |
Re: 850 vs. 8N
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Nolan on May 15, 2002 at 12:08:59 from (209.48.190.220):
In Reply to: 850 vs. 8N posted by Liz on May 15, 2002 at 09:28:44:
After the 850, an 8N will probably drive you nuts. The 8N has the hydaulics driven off the non-live pto. This means every time you push in the clutch, the hydraulics go dead. Major pain, since you cannot ever lift an impliment with your foot on the clutch. No power to the PTO with the clutch in makes it pretty much impossible to creep into things with the bush hog. Every time you touch the clutch, there's no power to the hog, so it slows to a halt. The nasty side of this is the PTO is driven throug the regular transmission, think of it is as a second driveshaft if you will. This means the PTO is connected to the rear wheels. If you're in gear, and something is spinning the pto shaft, the tractor is going to move, whether you push in the clutch or not. That's why salmoneye said you need a thing called an overruning clutch for using a hog on an 8N.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|