|
Tractor Talk Discussion Board |
Re: Mower for my 8N
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jim WI on April 29, 2002 at 10:32:27 from (63.161.86.254):
In Reply to: Mower for my 8N posted by Mark on April 28, 2002 at 08:46:53:
If you want it to look like it was mowed with a finish mower I think you'll pretty much need to use one. They're really designed for two different purposes. 'Course, you might find the quality good enough -- opinions seem to vary on this. A six-foot King Kutter finish mower will cost about $1000 around here (Mills Fleet Farm). The one I have does a good job behind my 2N and seems to hold up fine. I mow about 3 acres. I'm told that the 8N can handle a 6-footer when mowing in 3rd. On my 2N, 3rd is the road gear so I have to mow in 2nd. The 8N 3rd is a bit higher than the 2N 2nd so you'll get done faster.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Restoration Story: 1964 JD 2010 Dsl - Part 2 - by Jim Nielsen. Despite having to disassemble the majority of my John Deere 2010's diesel engine, I was still hopeful I could leave the engine-complete with crankshaft and camshaft-in the tractor. This would make the whole engine rebuild job much easier-and much less expensive! I soon found however, that the #4 conrod bearing had disintegrated, taking with it chunks of the crankshaft journal. As a resul
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|