|
Tractor Talk Discussion Board |
Re: Re: ring and pinion setup
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dave on April 16, 2002 at 17:06:36 from (152.163.205.53):
In Reply to: Re: ring and pinion setup posted by Bob /Ont. on April 16, 2002 at 16:13:58:
Bob,
thanks for the info. I may understand what needs to be done, but have never done it so I have no hands on knowledge of what a good contact pattern looks like. Also my first problem is how to set the pinion depth? My trans case is a solid rectangle with the only access point the very rear behind a cover. Looking in the case is like looking down a tunnel, with the pinion face facing towards me at the end of the tunnel. The shop manual shows a tool that slides into the carrier quills, giving a reference for the axle centerline and then shows putting a feeler guage in from the top as if the whole top of the trans case comes off to allow a view from above. No such luck, the top doesnt come off. Any idea on how to do this?
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Madison's County - by Anthony West. Philip Madison has been a good friend of mine for quite some time. He has patiently suffered my incessant chit chat on the subject of tractors for longer than I care to remember, and on many occasions he has put himself out, dropped what ever it was he was doing, to come and lend a hand cranking handles, or loading a find onto a trailer. Although he himself has never actually owned or restored a tractor, he was always enthusiastic and always around helping with other peoples projects.
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
