Tractor Talk Discussion Board |
Re: Finish mower on a Johd Deere M????
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by RayP(MI) on April 14, 2002 at 16:24:14 from (216.46.196.184):
In Reply to: Finish mower on a Johd Deere M???? posted by Pat Cox on April 14, 2002 at 04:11:44:
Pat, I have the same problem with the 2pt to 3pt conversion on my Farmall 200. 2Pt hitches have no width adjustment, and if I remember right it too was close to the 26" you mention. I have had to hunt around for tools that fit. I have a boom pole and a blade that I was able to fit by shimming the mounting pins outward with spacers made from pieces of pipe. I suppose a stack of washers would do too. You can buy mounting pins with longer than normal threaded sections that lend themselves to this modification. Blade is a "Farm Star" brand, purchased at a Quality F & F. Boom pole is burried behind other equipment in the tool shed right now, and I can't get to it. It was purchased at a Tractor Supply.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|