|
Tractor Talk Discussion Board |
Re: Lugging a Gasoline engine
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jon Hagen on April 14, 2002 at 10:32:23 from (63.160.195.124):
In Reply to: Lugging a Gasoline engine posted by FM on April 14, 2002 at 09:31:49:
Gear up and throttle back works for gasoline engines too as long as you don't overdo it. I would not run at less than 50-75% of full rpm if pulling a mid to heavy load. Kind of a rule of thumb is if you gear up and throttle back,you should be able to open the throttle and gain full rpm in a short time. If you open the throttle and gain rpm slowly or not at all you are lugging/overloading it too much. The throttle back gear up advice is for water cooled engines. Many air cooled engines need full rpm to get enough cooling.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|