|
Tractor Talk Discussion Board |
Re: I'm trying to learn to haul my tractor safely - have a question.
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by RonMC on April 11, 2002 at 23:56:14 from (24.83.76.183):
In Reply to: I'm trying to learn to haul my tractor safely - have a question. posted by Bill Oakes on April 11, 2002 at 18:52:30:
Hi Bill - I've done a fair bit of long-distance tractor hauling, bringing home junk from 2 provinces over and have learned at least 2 things. When you attach your chains, always make sure if something DOES loosen up, the chains won't fall off completely. When you attach to stake pockets, run the chain up the pocket so the hook will stay attached no matter what. I also do a 4-point chain/cinch job. Pull from each corner to the corners of your trailer, cinch the fronts so the tractor is where you want it fore/aft, then reef the cinches tight (a 3 foot pipe is about right)at the rear of the trailer. You should be able to stand on the chains without major deflection. Also, no matter what the law is in any particular state, TIE DOWN THE HANDLES !!! My last haul was a J-D "D" moved 1500 miles. The chains were checked after 5 miles, then at every stop or fill-up and nothing moved the whole trip. Make double sure to check absolutely everything before moving if you over-night, including test-applying the brakes as you begin to roll using manual application of the controller. After a while it all becomes habit and barring something you can't help - like an elk on the highway, you'll have no problems. Hope this helps, Ron
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|