|
Tractor Talk Discussion Board |
Re: Very Wierd Problem I need HELP!!!
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bill on March 29, 2002 at 15:53:27 from (209.81.167.225):
In Reply to: Very Wierd Problem I need HELP!!! posted by Martin Williams on March 29, 2002 at 08:43:57:
If the plug is bad it will do that. I can't explain why but put in a new plug and it will run. A hotter plug may help solve the problem. I also found that the float tab in the carb gets a nick worn into it from the needle valve. This may cause the valve not to seat and control the flow of gas. The engine will run rich and foul the plugs. I use fine paper (1000-1200 grit) to polish the nick out. It has worked for me and it is worth a try.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
It Can't Be Done! - A Tractor Story - by Neil Campbell. I'll never forget the time back when I was a boy baling hay on our Farm in Big Rapid, Michigan. The most memorable event that took place was a trip up the steepest incline on the farm pulling an old New-Idea baler with a pony-motor for power and a haywagon. I had just talked my Dad into buying an old John Deere B with 6-speeds ahead and I was real proud of it, except it was a little smaller than the Case tractor that we normally
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
