Tractor Talk Discussion Board |
Re: Re: NEED INFO. ON 54 FORD 2000 Industrial..
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Burrhead on March 17, 2002 at 20:21:20 from (12.83.4.153):
In Reply to: Re: NEED INFO. ON 54 FORD 2000 Industrial.. posted by JoeK on March 17, 2002 at 19:59:05:
That's right. The 2000 4 cylinder was only manufactured 01/01/1962-12/31/1964. There are 2 different 2000 Industrial types. Like JoeK says be sure about the hydraulic and PTO set up. Our local county road dept had some of the 2000 that did not have hydraulic systems but they had a PTO to use trailer type finish mowers in our parks. If there is a NH dealer around you can give him your 2000 serial number for advice on which manual you need. NH# 42200021 NH# 42400011 The cost is listed as $17.50
Follow Ups:
Home
| Forums
Today's Featured Article -
Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|