|
Tractor Talk Discussion Board |
Re: Hiring a surveyor ?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by old bones on March 06, 2002 at 18:06:58 from (207.177.105.69):
In Reply to: Hiring a surveyor ? posted by Rod MI on March 05, 2002 at 23:34:46:
you've got plenty of suggestions about finding/hiring a surveyor. one additional bit of advice if you live in town, or have neighbors that are close enough that you have to worry about them moving your stakes: immediately after the surveyor is done, make sure that you measure from an existing permanent something (ie-concrete driveway, house foundation, water shut-off, etc) from 2 directions to the survey stake, and use precise measurements. put these measurements in a safe place. survey stakes are set a little below ground level so they are not in danger of being disturbed by mowers, bare toes. in a short time, the survey stakes are covered with dirt, gravel, sod, whatever. If you need to locate these stakes in the future, just dig out the tape measure and use a spade to uncover them. as far as what to do about dishonest neighbors, every location seems to have a few, and they all require a different treatment. i'm in rural iowa and don't have to worry about neighbors in my yard. i'm surrounded by 320 acres and the survey stakes are in the fencerows and middle of the roads. as far as using concrete to mark the stakes, this is an excellent solution, but make sure that you dig the hole so that it is completely on your side of the property line. don't put the hole centered on the survey stake. if you do, it is technically half on the adjoining property owner's land, and he can pull it out, dig it up, or whatever he wants, and you can't do anything about it.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
A 1937 John Deere Unstuck - by Gary Hickman. Here is my story of how I got the pistons out of a 1937 JD B that the engine had been stuck for about 14 years: About 12 years ago my Dad gave me one of the tractors I ran as I was growing up on our farm in central Nebraska. The engine on this tractor, a 1937 John Deere "B", had been stuck for 2 years before he gave it to me. This last spring (1999) I hauled the tractor to our 2 acre lot in St. Libory Nebraska where it joined my antique machinery collection, at that time a 1929 Caterpillar T
... [Read Article]
Latest Ad:
2555 Mahindra Shuttle 4x4 heat,air,diesel,7ft Mahindra heavy duty bushhog 7ft snowblade bucket
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|