|
Tractor Talk Discussion Board |
Re: Plowing -- how to instructions
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by dap on February 13, 2002 at 12:49:14 from (138.87.47.57):
In Reply to: Plowing -- how to instructions posted by dap on February 12, 2002 at 10:52:16:
I really appreciate all of your comments and suggestions. I've ordered the manual and parts catalog for the plow already. I haven't seen the plow yet (I'm getting it next Friday), so I may have to put in some work to get it ready to plow. I'm also getting the MT-200 2-row cultivator and the set of rear wheel weights Grandpa had with the tractor. All of these were sold with the MT in 1986. I tracked down all of these during the last 1.5 years -- brought the tractor home in September of 2001. I'll update you on how it all goes! Thanks, Darryl
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|