Tractor Talk Discussion Board |
Re: Calcium chloride eating my rims!
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by ScottyNY on February 12, 2002 at 15:42:55 from (128.59.42.119):
In Reply to: Calcium chloride eating my rims! posted by Scott from New York on February 12, 2002 at 13:59:23:
At the very least, you need a new tube. I wouldn't mess around with patching. AS for the rim, it's got to be cleaned up and real thoroughly. Take the tire completely off and clean the rim inside and out. Can't hurt to make sure the tire bead is clean, too. If needs be, sandblast and paint can't hurt. If the corrosion around the stem is bad enough that it might wear or cut the stem, I'd weld a larger patch over the old hole, inside or out and bore a new hole for the stem, being sure to clean up any burrs or edges. If the corrosion is worst around the stem, there's a pretty good chance there's a leak right there. Don't forget to unload the other tire. Good luck! Scotty
Follow Ups:
Home
| Forums
Today's Featured Article -
My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|