|
Tractor Talk Discussion Board |
Re: Plowing -- how to instructions
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by ---===] jer [===--- on February 12, 2002 at 14:27:28 from (192.28.2.6):
In Reply to: Plowing -- how to instructions posted by dap on February 12, 2002 at 10:52:16:
I know what you mean, wanting to plow with a mounted plow on a JD model M. It allows you to get back into the corners and turn the soil. But, I mounted the two-bottom plow, and I bought the operators manual. I see that starting out, you adjust the large screw on the plow's front right hand side to level the plow as was mentioned in an earlier post. After you plow the first slice and the tractor is running in the furrow, the screw that leveled the plow with both right wheels out of the furrow, now goes the other way and levels the plow with one set of wheels IN the furrow. I hope you enjoy it as much as I do. Good luck. ---===] jer [===---
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|