|
Tractor Talk Discussion Board |
Re: rear tractor tire wont pop up on bead
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by JMS/MN on June 16, 2007 at 18:11:04 from (204.73.106.15):
In Reply to: rear tractor tire wont pop up on bead posted by super_m on June 16, 2007 at 09:54:18:
Believe what the others said- regarding psi- way too high. I just did some duals- ran them to 25 psi, rode them down the road, but they still would not seat. Popped the bead, brushed them with soap/water mix, and reset them, aired them up and they set properly. Sometimes I pump them up, do the hammer thing, etc, and let the air out again. Always use the soap and water thing. Sometimes it takes 2-3 times, inflating and releasing air, repositioning the tire on the rim. But never pump them as high as you did. They can blow up and kill you.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|