|
Tractor Talk Discussion Board |
Re: Need help with pick-up truck transfer case, no 4x4 anymore.
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Salmoneye on February 12, 2002 at 03:16:47 from (207.40.137.64):
In Reply to: Need help with pick-up truck transfer case, no 4x4 anymore. posted by Canadian Cowboy on February 11, 2002 at 19:37:44:
When was the last time you R&R'ed the hubs?
I have seen them get water inside and freeze thereby not allowing the cog to engage the splines. I would have to heat the lockout knob with a propane torch for a minute and then work the knob from locked to unlocked a few times before it would engage. Cure is to remove, clean, inspect and repack the lockout hubs with grease...no jacking involved and a cheap fix...
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Farming Never Left My Blood - by Stan Gordon. I was born in 1947 youngest of ten of a working farm. Our farm was located in Saskatchewan near Saskatoon. We had a mixed farm consisting of grain and dairy all done with old machinery and by hand. My dad had a tractor, a Farmall A which was used mostly to run the thrashing machine, a seed drill and for plowing. I remember locals used to help each other and threshing was done from daylight to after dark, one farm to another until all farms were done.
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
