|
Tractor Talk Discussion Board |
Re: 9N Tractor
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Salmoneye on February 04, 2002 at 06:43:15 from (207.40.137.44):
In Reply to: 9N Tractor posted by Rick Hershman on February 03, 2002 at 12:02:01:
Um... If you are talking abou the lower pin that is attached to the rear end, you will have to remove the axel trumpet to get at the castelated nut on the back side.
There is no gasket, and when you get in there you may find that the hole is 'wallered' out from the movement. Clean up the hole, slap some JB WELD in there, replace the pin. and then torque the heck out of that nut and hope for the best... Also...Post this on the Ford N Board...Think they will tell ya the same though...
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
65 massey ferguson diesel
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
