Tractor Talk Discussion Board |
Re: Re: fan belt replacement on OC3
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by P0LK CRAWLER on January 30, 2002 at 07:38:24 from (158.104.97.28):
In Reply to: Re: fan belt replacement on OC3 posted by George Gibby on January 30, 2002 at 06:59:24:
GG: on dozer and crawler board got a reply about using belts that can be taken apart; response was almost any heavy equipment/tractor dealer would have them, braided appearance with rivet looking buttons to hook proper length together. I had seen such advertised for power shop tools but did not know they were available for other equipment. Hooboy!!would not look forward to the procedure involving removing pump and coupling. Lord have mercy on us neophytes! Thanks for the reply. PC
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|