|
Tractor Talk Discussion Board |
Re: 3-point backhoe attachaments and info.
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by F14 on January 26, 2002 at 09:21:12 from (216.204.137.72):
In Reply to: 3-point backhoe attachaments and info. posted by mobob on January 26, 2002 at 08:38:42:
I have a Woods. It's completely self-contained, with it's own pump and reservoir. Fit's any 3-point hitch. I can put it on or take in off in 10 minutes, less on a good day. Mine is a 6.5 foot reach with a 16" bucket, mounted on a 20 horse JD compact diesel (750). I've had it for 10 years, and it's done everything I've ever asked of it, with only minor problems. On a backhoe, you have to consider things like hoses and cylinder seals consumables, and plan to replace them as they wear out. I've had to weld on it twice, both times due to severe abuse rather than any fault of the equipment. I'd buy another Woods in a second. Other manufacturers are out there, like Kelley and Bush Hog to name a couple. I like the self contained hydraulics, faster, more efficient, less wear and tear on the tractor. I'm not sure where I stand on the subframe vs. 3-point mount issue. I haven't had any troubles with my 3-point, but the idea that the subframe spreads the stresses out to avoid damaging the tractor is attractive to me. If I were going to use a hoe any bigger than the one I have (which is relatively small as hoes go) I'd sure look hard at the subframe types. Takes a little longer to put them on, but I suspect it's worth it in the long run.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
1938 John Deere LI
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|